Results 1 to 2 of 2
  1. #1
    injected2stroke's Avatar
    Join Date
    Feb 2006
    Taylor Mi.

    Impeller Housing

    Ok so I am helping a out a friend from here on the forum with some issues on his boat and notice after pulling out the pump the the wear ring looks a little rough kind of like it was pushing all the sand on the bottom of lake Erie through it. Even though there isn't a noticeable step or groove in it's diffenately needing to be cleaned up should I try to wet sand it out or should it be fitted for an insert? And where is the best place to get it repaired?

  2. #2
    billy's gpr's Avatar
    Join Date
    Mar 2007
    central coast...nsw...australia
    island racing to a wear ring,that is plastic and in future thay are a lot easyer and cheaper to replace

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. 2004 GTX 4 Tec Impeller Housing Replacement
    By coach mike in forum Sea Doo Open Discussion
    Replies: 1
    Last Post: 06-18-2007, 08:25 AM
  2. Bad impeller housing...
    By OutlawGPR in forum Yamaha PWC Performance (2-stroke)
    Replies: 6
    Last Post: 01-15-2007, 10:05 AM
  3. Clearance on impeller/housing.....
    By OutlawGPR in forum Yamaha PWC Performance (2-stroke)
    Replies: 2
    Last Post: 01-13-2007, 09:51 PM
  4. Replies: 2
    Last Post: 12-12-2006, 10:13 PM
  5. Impeller housing...Plastic
    By Troy Hammond in forum Yamaha PWC Performance (2-stroke)
    Replies: 1
    Last Post: 07-08-2006, 02:05 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts