Thread: Ported 1200 or standard 1300
09-19-2007, 05:13 AM #1
Ported 1200 or standard 1300
About rebuild single pipe gp1200r,my budget allows me to bore/plate my standard cylinder to 1300 or buy a excellent set of used ported 1200 cylinders,i know port 1300/1390 would be to go but to budget down allow for this,but it would be nice,what do you guys think?
09-19-2007, 06:34 AM #2
What are you after Billy, just top end or a good quick ski?
I was toying with the same, but because I want a very quick holeshoting ski, and am no too bothered about over 70mph skis-Im going to go big bore.If it's flat enough to go over 70 mph-I take my blaster out!
09-19-2007, 07:26 AM #3
hopefully a good all rec ski,with good holeshot
09-19-2007, 07:30 AM #4
porting doesn't do much to the 1200 cylinders - expensive for a small gain
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By KawieGuy in forum Yamaha ClassifiedsReplies: 20Last Post: 02-04-2010, 12:19 AM
By hunting080189 in forum Yamaha Open DiscussionReplies: 3Last Post: 06-25-2009, 12:55 PM
By akatitan in forum Yamaha ClassifiedsReplies: 0Last Post: 01-18-2009, 11:00 AM
By gzk in forum Yamaha ClassifiedsReplies: 0Last Post: 10-14-2008, 05:55 PM
By JIM'S PERFORMANCE in forum Yamaha ClassifiedsReplies: 2Last Post: 07-29-2008, 07:58 AM