Thread: Good project for someone
09-20-2007, 02:07 PM #1
Good project for someone
Was considering it, but i'm just too far away. Being in college doesn't help me either. From what the seller says, you would be able to have a good boat for minimal $$. He claims the bore to be 86.5mm, I don't know the max bore on the cylinders though. Probably a crank, 3 pistons and rings, and maybe one oversize bore job. Only thing I'd worry about is that 86.5mm number.
09-20-2007, 02:17 PM #2
I dont know where you get pistons bigger than 86mm so I think you would be looking at new sleeves and porting.
Does L,Horning have a source for pistons 86.5mm or bigger.
09-20-2007, 02:22 PM #3
Scotty, isn't that the guy you had all the problems with?
09-20-2007, 02:23 PM #4
09-20-2007, 02:27 PM #5
none-the-less you could have a good ski for less than the cost of a stock one.
09-20-2007, 02:30 PM #6
I agree if your local and can look it over its worth a look.
you can put a stock top and on it for $600-$700 or less.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Rampage in forum Sea Doo Open DiscussionReplies: 7Last Post: 07-28-2009, 08:10 PM
By caliburst in forum Sea Doo 4Tec SkisReplies: 4Last Post: 12-01-2008, 05:06 PM
By caliburst in forum 4-Tec PerformanceReplies: 2Last Post: 11-30-2008, 11:11 AM
By caliburst in forum Sea Doo Open DiscussionReplies: 2Last Post: 11-30-2008, 11:11 AM
By Region8Ultra250X in forum Conversion Skis ClassifiedsReplies: 0Last Post: 09-03-2007, 02:27 PM