09-20-2007, 02:15 PM #1
Needing Servo motor Connection help..
alright, I have everything hooked up, except the 2 wires that connect to the circle piece on the 3d cylinder.
How do I get that little piece at the end of the wires to go into the fitted pieces on the circle piece?! I looked at the direction manual, and saw that they go "sideways" but I cant get them to go in..
09-20-2007, 02:54 PM #2
needing help quickly....
09-20-2007, 02:57 PM #3
you need to disconnect the cable from the holder than slide the lead slug into the circle thing and reconnect the cable to the bracket.
09-20-2007, 02:59 PM #4
so undo the ones in the motor part.. then hook the ones on the circle, and then re-attach the motor ones???
and the ones on the circle.. i just push them in?
09-20-2007, 03:03 PM #5
Unhook the cable ends from the bracket near #3 cylinder.
09-20-2007, 03:13 PM #6
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By gglattli in forum Yamaha Open DiscussionReplies: 2Last Post: 04-06-2015, 02:06 PM
By luckyalex58 in forum Yamaha PWC Performance (2-stroke)Replies: 3Last Post: 02-01-2011, 08:05 PM
By handybuilder in forum Yamaha ClassifiedsReplies: 1Last Post: 08-13-2008, 03:10 PM
By HallPass in forum Yamaha How To & FAQsReplies: 5Last Post: 09-20-2007, 03:13 PM
By ryan*9 in forum 2-Stroke PerformanceReplies: 30Last Post: 08-07-2007, 11:44 PM