Thread: oil ratio for breakin in remix
09-21-2007, 09:10 AM #1
- Join Date
- Aug 2007
oil ratio for breakin in remix
hey guys i just did an angine rebuild that was seazed and now i went premix and trying to find out for the first tank what do i premix
09-21-2007, 09:29 AM #2
32:1 with non synthetic/mineral 2 stroke oil
09-21-2007, 09:32 AM #3
I run mine 28:1 for break in.
09-21-2007, 10:08 AM #4
remeber to go easy on rpms for tank and a half of heavy oil premix, no wide open runs, and vary the rpms. after that ride it hard. I thin k there will be a lot of differing opinions on breakin technique posted shortly,
I think the key is lots of oil, and retorque things (head etc) after getting heat cycle thru engine , only do this if you did not use loctite
09-21-2007, 10:13 AM #5
And remember that the more oil you put in the premix, the more you need to back out on the high and low speed needles because you are getting less fuel.
09-21-2007, 11:02 AM #6
I personally use Yama-lube for my break-ins @ 28:1. Jeff made a great point about the fuel,more oil parts per gallon,the less fuel particles you have,turn the fuel screws up and BRING EXTRA PLUGS.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Ultra151 in forum Kawasaki Open DiscussionReplies: 10Last Post: 07-05-2010, 09:50 PM
By Metal4130 in forum Yamaha Open DiscussionReplies: 1Last Post: 07-12-2007, 07:44 AM
By Robsauto2 in forum Yamaha PWC Performance (2-stroke)Replies: 9Last Post: 04-29-2007, 11:31 AM
By sic fish in forum Yamaha How To & FAQsReplies: 2Last Post: 03-19-2007, 06:52 PM
By AMG ETR in forum Sea Doo Open DiscussionReplies: 12Last Post: 05-21-2006, 04:01 PM