Thread: RXP throttle conversion
04-16-2006, 10:07 AM #1
RXP throttle conversion
I was just telling myself, "self this is the easiest mod there is on these", then When putting the new throttle cover on I realized there is no hole for the push pin in my steering pad. Anyone else have this problem. Also this new cover doesn`t fit worth a damn.
04-16-2006, 10:07 AM #2
Also wanna say these stock handle bars aren`t worth a damn. You`d think that Seadoo would have at least painted them.
04-16-2006, 10:19 AM #3
How do I install this throttle cable into the handle? This handle is threaded and the cable end isn`t. Do I have the wrong kit?
04-16-2006, 10:33 AM #4
read the directions HOSS. It's easy
04-16-2006, 10:44 AM #5
I did,,doesn`t say anything about the push pin but put it in. There is no hole. The throttle cable says install it. But you can`t screw it into the handle.
04-16-2006, 10:52 AM #6
Re: RXP throttle conversionOriginally Posted by HOSS
yes the new throttle cover isin't an exact match color and finish.
as for the hole for the push pin, you have to drill a hole in the sterring pad in order to install the push pin.
before you do this make sure you install the supplied cover onto your steering pad tightly,then push your throttle conversion kit onto your supplied cover as tight as possible then mark the hole of where you need to drill your steering bar to hold the throttle cable conversion kit with the supplied drill bit.
remove everything and drill the hole.
that alone without drilling your sterring pad will hold that cover in place.
you can find the instruction on the riva racing site.
i am not that mecanically good and i did a good job.
i hope this helps
04-16-2006, 11:07 AM #7Originally Posted by HOSS
04-16-2006, 11:15 AM #8
Prob is then its gonna fit even worse. I`ll have to push the pin in one click so it doesn`t start to ride up. But the throttle cable is my biggest concern. What do you do? Cut the rubber grommet off of the casing?
04-16-2006, 11:28 AM #9
OK,,,its the nipple on the end of the casing. It won`t fit into the brass fitting on the handle. Tried everything I got. It ain`t goin in. Say by by nipple.
04-16-2006, 11:39 AM #10
Tried everything but a simple lil` ol` file. That is the easiest mod.
Catch this Kanuck cause I`m only gonna say this ONCE,,,,I`m a dork.
Now back to me being an acehole. Thanks for the help everyone.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By ronefx in forum 4-Tec PerformanceReplies: 0Last Post: 08-25-2013, 03:07 PM
By buddydoo in forum 4-Tec PerformanceReplies: 36Last Post: 07-17-2007, 08:04 PM
By meirvin in forum Sea Doo Open DiscussionReplies: 8Last Post: 03-12-2006, 07:44 AM
By chitownrxp10 in forum 4-Tec PerformanceReplies: 6Last Post: 01-05-2006, 04:20 PM
By rlara in forum 4-Tec PerformanceReplies: 14Last Post: 10-07-2005, 05:48 PM