Thread: 4tecs... any grease points??
11-09-2007, 05:29 AM #1
4tecs... any grease points??
ok i have read all about the fancy driveline seals, to replace the accordion boot carbon ring etc.
but i cant seem to find any info on a STOCK 4tec engine, GTX NA, GTX SC, RXP, RXT
are there any grease fittings like on the old seadoos???
on the old doos, located at the rear of the engine, under that big gray shaft/PTO cover, was a ZERK fitting to grease the shaft bearing...
does a 4tec have the same thing???
i know my 03 xpdi still has it, but i cant find any on the 03 GTX SC.
if not how does the driveline shaft/bearing get stabilized lubricated sealed??? aka where is the bearing on the engine side??
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Jeff G in forum Polaris Open DiscussionReplies: 2Last Post: 08-01-2013, 10:41 PM
By lbrown in forum Polaris How To & FAQsReplies: 4Last Post: 07-15-2010, 05:52 PM
By kpollock2249 in forum Yamaha How To & FAQsReplies: 2Last Post: 02-15-2009, 09:16 PM
By npara in forum Sea Doo Open DiscussionReplies: 7Last Post: 01-30-2009, 12:36 PM
By njseadooer in forum Sea Doo Open DiscussionReplies: 13Last Post: 03-24-2007, 10:31 AM