Results 1 to 2 of 2
  1. #1

    Join Date
    Jul 2007
    Montgomery, AL

    Question Location for hole for rear exhaust

    I am about to cut the hole for the exhaust (riva location). I have their templet and I cut out for the tie-down loop but it does not fit up against the hull under the rub rail. With the cut out space around the washers on the tiedown loop the templet is even with the bottom of the rub rail. Is this right? I want to make sure because you only get one shot.

  2. #2
    Site Admin Green Hulk's Avatar
    Join Date
    Apr 2005
    Morgan City, LA
    That is right. Drill the hole

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Hole for rear exhaust
    By bryantjopplin in forum Yamaha PWC Performance (4-stroke)
    Replies: 17
    Last Post: 04-22-2013, 03:53 PM
  2. cutting hole for rear exhaust tip, advice?
    By KeithKman in forum 4-Tec Performance
    Replies: 21
    Last Post: 07-18-2009, 01:14 AM
  3. Replies: 21
    Last Post: 02-14-2008, 03:42 PM
  4. Hole saw size for rear exhaust?
    By mstennes in forum 4-Tec Performance
    Replies: 27
    Last Post: 12-04-2007, 07:44 PM
  5. Danny, rear exhaust for $20
    By lafjax in forum 4-Tec Performance
    Replies: 1
    Last Post: 08-26-2007, 12:23 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts