Thread: ummm?? INJECTORS
11-21-2007, 08:32 PM #1
Yeah i just installed the 42# injectors and they seem not to sit all the way down to the case. like you can see some of the injector pased the rubber seal that is on the bottom. is this normal?? ill post a pic if you need to but i dunno what to think!
11-21-2007, 09:01 PM #2
Hmmmmm, I almost want to get off the nice comfy couch, trot out to the freezing ass garage and install my injectors. I said almost
11-21-2007, 10:39 PM #3
Ok just got in from installing the injectors.
after undoing the tie wraps it was a lot easier.
when I put the fuel rail back in the injectors seemed to snap in just like the stock ones did when I winterized.
As sticky mentioned I can see some silver of the injector shaft, no oring is visible but the shaft is.
Is that correct?
11-21-2007, 10:45 PM #4
My 42's Looked The Same But They Have Been Doing Great For 2 Months
11-21-2007, 10:47 PM #5
11-22-2007, 08:21 AM #6
11-22-2007, 09:34 AM #7
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By theantiRXP in forum 4-Tec PerformanceReplies: 9Last Post: 04-20-2006, 03:13 AM
By Kinchyle in forum 4-Tec PerformanceReplies: 35Last Post: 04-12-2006, 07:56 PM
By Kinchyle in forum 4-Tec PerformanceReplies: 19Last Post: 04-12-2006, 08:33 AM
By Green Hulk in forum 4-Tec PerformanceReplies: 12Last Post: 04-06-2006, 02:29 AM
By Green Hulk in forum 4-Tec PerformanceReplies: 18Last Post: 06-17-2005, 02:21 PM