12-02-2007, 08:37 PM #1
Retrofitting a GSX Digital Gauge to an RXP
I am trying to figure out what the sending unit on our skis needs to operate.
I have a shop manual and it just shows the two wires going to it but there is no explanation of what they are?
Is it sending 12v to it and gaging the output or sending a ground signal and gaging resistance?
I am trying to retro fit a gauge from an older model to the RXP, I had the trim and spedo working on the gauge and it blew out before I could get the mode button to scroll through all the menus. I think I know what caused that issue but am at a loss as to the sending unit as I do not have a ski to test with.
Anyone that has done this any help would be great.
12-02-2007, 08:47 PM #2
god bless seadoo and however they figured out to run 18 functions in the gauges thru like 1 wire!
12-02-2007, 11:11 PM #3
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By jdogg in forum Polaris Open DiscussionReplies: 11Last Post: 05-08-2010, 11:35 AM
By Petron in forum Sea Doo ClassifiedsReplies: 0Last Post: 07-14-2009, 04:43 PM
By Discobrian24 in forum Sea Doo ClassifiedsReplies: 2Last Post: 02-16-2009, 09:31 PM
By duramaxxed in forum Sea Doo Sport BoatsReplies: 10Last Post: 08-05-2008, 08:03 AM
By XSV in forum Sea Doo ClassifiedsReplies: 12Last Post: 05-15-2008, 12:35 AM