Thread: Riva PV Part #'s for 66e
12-16-2007, 07:40 PM #1
- Join Date
- Jun 2007
- Mooresville, NC (Lake Norman)
Riva PV Part #'s for 66e
Does anybody happen to know the SD part compatability that ties into the Riva Gas PV kit they sell? The list of parts from their instructions below:
Listed SD Parts:
What OEM application from SD are these parts from? 951, 787, etc, DI or not? I'd like to be able to source the parts used, or get them for cheaper than the $129.95 that Riva sells the SD parts for.
Any help would be greatly appreciated! Thanks!
12-16-2007, 10:18 PM #2
2001 XP is what I read before. (All carb 951's should be the same). I wouldnt use one from a DI boat I think they are different.
12-16-2007, 10:35 PM #3
i was reading those directions where does step 3 go?
i just took my shafts out and tapped plugs into the cyl where the seals were?
12-16-2007, 10:39 PM #4
For the plugs Lowell suggested JB weld to hold them in. In that case you wouldnt tap anything.
12-16-2007, 10:40 PM #5
12-17-2007, 01:19 AM #6
you running twin pipes? They wont fit with the single pipe set up on the 66E. You will never get the pipe back on
12-17-2007, 01:20 AM #7
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By washingtonrider in forum Yamaha ClassifiedsReplies: 8Last Post: 04-27-2009, 04:43 PM
By Kohl531 in forum Yamaha ClassifiedsReplies: 5Last Post: 04-23-2009, 09:34 PM
By Green Hulk in forum Yamaha PWC Performance (4-stroke)Replies: 0Last Post: 05-09-2008, 03:12 PM
By Green Hulk in forum Kawasaki PWC Performance (4-stroke)Replies: 70Last Post: 01-25-2007, 06:45 PM
By 01xdime in forum 4-Tec PerformanceReplies: 2Last Post: 11-19-2005, 09:11 AM