12-23-2007, 01:38 PM #1
How to remove rubrail, and where to buy black??
I need to remove the rubrail on my 04 RXP, whats needed? Im getting the ski painted, and want to replace the inner strip of rubrail with black instead of the yellow? Anyone know where to get this stuff at a reasonable price?
Thanks in advance
12-23-2007, 01:51 PM #2
They just pop on. You can just get a screwdriver under oneside or the other and just pull them out. If you are reall anal. Pull the front nose piece off and then slide out.
When you get the new ones. Just line them up and tap kinda hard with your hand to set them in place.
12-23-2007, 01:58 PM #3
- Join Date
- Dec 2007
- Christchurch NewZealand
yip just pull them out from one end if its a cold day pour hot water on them first as they get hard and can be brittle in cold weather, same goes for install hot water then tap the new strip in place.
I think they are not to expensive from seadoo.
12-23-2007, 11:12 PM #4
So you think seadoo offers the center section of the rail in black? Ive only seen them in color, like green, red, yellow.
12-23-2007, 11:14 PM #5
- Join Date
- Nov 2007
- Odessa, TX
12-23-2007, 11:26 PM #6
12-23-2007, 11:28 PM #7
- Join Date
- Jul 2005
- Lake Dunlap, Texas
Go to your local Sea-Doo Dealer and order rub rails for a GTI. The come in black. Order both side rails and the rear rub rail. Remove the rounded nose piece and the two rear corner peices--pull out the old rub rail and install the new ones--they just push in. If I remember correctly you might have to cut a few inches off the side rails.
Last edited by Sundance; 12-23-2007 at 11:31 PM.
12-24-2007, 09:10 AM #8
Great guys I appreciate the help!
12-24-2007, 09:44 AM #9
12-24-2007, 09:51 AM #10
If Im not mistaking the 2007 Yellow RXP has black rub rails also..
And the Red one has the black grab handle..If you get the 07 rub rails you wont have to do any cuttting.Just pull out the old ones and snap in the new ones...Talk to Jerry he can probley get these for you cheaper...Good luck
Here is the part numbers youl need:
Side molding: 7MOULURE PARECHO*SIDE TRIM (Noir, jaune )
10MOULURE PARECHO*TRIM-BUMP.REAR (Noir, jaune )
And rear grab handle:16POIGNEE *GRAG HANDLE ( )
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By floridajetski in forum Kawasaki PWC Performance (4-stroke)Replies: 10Last Post: 08-01-2012, 09:39 PM
By playyas4u in forum 2-Stroke PerformanceReplies: 4Last Post: 08-01-2011, 03:55 AM
By Turbo Nick in forum Sea Doo Open DiscussionReplies: 17Last Post: 10-12-2007, 09:41 PM
By Vengeance Racing in forum Kawasaki PWC Performance (4-stroke)Replies: 21Last Post: 05-25-2007, 12:46 AM
By NeVerMind in forum Yamaha PWC Performance (2-stroke)Replies: 6Last Post: 05-24-2006, 04:31 PM