Thread: A couple of questions...
12-27-2007, 03:59 PM #1
A couple of questions...
I have re-located my waterbox exit at the rear of the waterbox and now the lead for the temperature sensor will not reach, will it be a problem for me to solder in another 4 -5 inches of wire to make it reach?
Also I need to drill and tap my intercooler block-off for my FPR, what size drill bit do I need to use to screw the 1/8 NPT tap into?
Thanks in advance,
12-27-2007, 04:06 PM #2
Grant, you will have no trouble soldering in the wire to lengthen it.
You will need a 1/8 NPT tap and i think a 23/64 drill bit to tap your stock IC blockoff.
12-27-2007, 04:08 PM #3
BTW, you don't have to put a fitting into your stock IC blockoff for the FPR. On top of each intake runner is a nipple. Just drill one out, slide the sensor hose for the FPR on over it and then use a zip tie to tighten up the hose on the nipple.
12-27-2007, 04:16 PM #4
I see thanks for the quick reply Jerry,
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Armand28 in forum Sea Doo Sport BoatsReplies: 3Last Post: 05-26-2007, 04:40 AM
By SeanJ in forum Sea Doo Open DiscussionReplies: 6Last Post: 05-13-2007, 11:46 PM
By aussie rxp in forum 4-Tec PerformanceReplies: 5Last Post: 03-06-2007, 01:02 AM
By OzVirage in forum Polaris Open DiscussionReplies: 6Last Post: 02-12-2007, 08:39 PM
By jcc011185 in forum Polaris PWC PerformanceReplies: 171Last Post: 11-04-2006, 06:50 PM