Thread: pto support tool
05-01-2006, 11:11 AM #1
pto support tool
Is this really necessary when removing the drive shaft?
05-01-2006, 12:06 PM #2
I don't use any tools when i remove mine.
I pull the slide ring back with my bare hands and then pry out the circlip with a little flathead screwdriver.
05-01-2006, 12:15 PM #3
and that is why you are called the hulk
I just yanked on the slide ring to see if I could pull it without the tool, but I found something interesting. The entire part circled in yellow moves. This is the driveshaft and it shouldn't move this much should it? I'm talking about half of an inch of play Is this normal? I am pulling on the correct part aren't I? the part I'm pulling on and the direction are in red.
I know I have to remove everything to do this. All the parts are still installed in the picture because I don't want to remove the SC and everything until I have all the parts in since I can still ride....have to minimize my down time.
05-01-2006, 12:21 PM #4
Jerry can you get the carbon seal?
05-01-2006, 12:27 PM #5
Yes, the drive shaft may move back with the slide ring a little bit.
I can get the carbon rings, but it takes me forever. Its best you deal with Riva, or whomever direct on something like that.
05-01-2006, 12:30 PM #6Originally Posted by Green Hulk
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By ubernoob in forum 4-Tec PerformanceReplies: 1Last Post: 03-05-2012, 01:03 PM
By thompsdw in forum 4-Tec PerformanceReplies: 4Last Post: 07-11-2011, 10:30 AM
By attila in forum Sea Doo ClassifiedsReplies: 6Last Post: 01-16-2011, 04:28 AM
By MJE in forum Kawasaki PWC Performance (2-stroke)Replies: 5Last Post: 06-06-2010, 11:53 PM
By CarFanatic in forum Sea Doo ClassifiedsReplies: 4Last Post: 11-06-2009, 10:28 AM