Thread: Bored out pump?
01-03-2008, 12:31 PM #1
Bored out pump?
JasonZE I think mentioned this in a thread ... bore out the SS pump liner and have the impeller edge built up to match. Anybody have any news at all on actually doing this and the results? As HP goes up, a larger pump can be better at turning that into thrust, all else being equal ...
01-03-2008, 10:33 PM #2
I am running a rxp pump bored out to 165mm on my v6 gsx the bottom end hook up is unreal
01-04-2008, 01:01 AM #3
- Join Date
- Dec 2007
- Christchurch NewZealand
I will have to check the specs but it is only for hook up on the start line and this stage in theory only as we have never run one like it.
Hope to be running in the next few weeks so will let you know.
01-04-2008, 09:34 AM #4
Thanks Jason, keep us posted on the results ...
Kenny, did you just bore the liner and leave the diameter of the pump (vane area) the same, or did you bore that out as well? Did Skat make you a special prop to fit it?
01-04-2008, 03:08 PM #5
Yes skat made the prop for me I cut as much as I could out of the pump but there is not a lot of meet there
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By jarcynvicnchris93 in forum Polaris Open DiscussionReplies: 3Last Post: 06-18-2008, 12:28 PM
By timmy_philson in forum Honda PerformanceReplies: 4Last Post: 02-27-2008, 08:58 PM
By yellow4 in forum 4-Tec PerformanceReplies: 5Last Post: 06-21-2007, 09:05 PM
By 01xdime in forum 4-Tec PerformanceReplies: 1Last Post: 08-16-2006, 09:33 PM
By johnD in forum 4-Tec PerformanceReplies: 27Last Post: 07-11-2005, 08:06 AM