Thread: R+D girdle kit?
01-06-2008, 09:22 PM #1
01-06-2008, 09:22 PM #2
Todd, it sure will. It will require some retro fitting for the Riva grate, but works well.
01-06-2008, 09:23 PM #3
and that reminds me. I am going to install one of these on my 07 RXP right now while im swapping ride plates to prevent a pull out of the inserts.
01-06-2008, 09:54 PM #4
Thanks, I'm ordering one now. It pulls out the middle hole on the grate and ruins it. The last one was on it's first ride. It's at a heliarc guy for repair.
01-06-2008, 10:29 PM #5
- Join Date
- Aug 2007
So this holds the grate in place?
01-06-2008, 11:00 PM #6
It prevents the grate from pulling out the inserts in the pump shoe
01-06-2008, 11:24 PM #7
01-06-2008, 11:25 PM #8
- Join Date
- Nov 2007
- Odessa, TX
01-06-2008, 11:39 PM #9
BTW... the '08 RXT-X will probably be able to use this piece because the rear of the grate and the bolt pattern is now the same as the RXP. I don't know if this applies to the new '08 RXT/GTXs, but I would think so.
01-07-2008, 08:16 PM #10
On mine two holes were drilled to the pump area and two longer bolts were sent in and capped off with a pair of ss washers and nuts....Damn it I saw the ski today and forgot to take a picture of it! Maybe tomorrow....
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By dav_dman in forum 4-Tec PerformanceReplies: 13Last Post: 06-24-2009, 08:05 AM
By Paul T in forum Yamaha ClassifiedsReplies: 3Last Post: 05-08-2008, 08:29 PM
By mxl16 in forum 4-Tec PerformanceReplies: 16Last Post: 03-20-2008, 12:16 PM
By Shibby1485 in forum 4-Tec PerformanceReplies: 11Last Post: 02-11-2007, 07:32 PM
By rxpblast in forum Sea Doo Open DiscussionReplies: 2Last Post: 07-29-2006, 12:25 PM