Results 1 to 3 of 3
  1. #1
    JeffSki's Avatar
    Join Date
    Nov 2006
    Location
    Florida 33410
    Posts
    218
    +1
    4

    Can Someone Help Me With Oem 1200 Carbs?

    If you remove and look under the needle/seat you can see a restrictor for the return line on the center and rear carb, but not the mag carb. Is that normal? These are for a 04 STXR. Thx, Jeff


  2. #2
    JeffSki's Avatar
    Join Date
    Nov 2006
    Location
    Florida 33410
    Posts
    218
    +1
    4
    Actually after looking closer, I see the restrictor is drilled in to the casting of the body on the mag carb. That's why there's not a brass restrictor jet.

    Back to the drawing board.

  3. #3
    thesepaperwings's Avatar
    Join Date
    May 2007
    Location
    South East Kansas
    Posts
    1,283
    +1
    1
    Just ditch them and buy a set of NOVIS

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Can someone help me with VTECH auto tune
    By pedro15 in forum 4-Tec Performance
    Replies: 3
    Last Post: 09-14-2015, 04:52 PM
  2. can someone help me with where these two fuel lines go on my ZXI?
    By chvscks319 in forum Kawasaki How To & FAQs
    Replies: 2
    Last Post: 06-17-2011, 08:49 AM
  3. Can someone help me resize this animated gif?
    By Jeff C in forum Sea Doo Open Discussion
    Replies: 11
    Last Post: 04-06-2006, 09:38 PM
  4. Can anyone help me with my impeller shaft and new prop?
    By ccassone in forum 2-Stroke Performance
    Replies: 0
    Last Post: 02-10-2006, 03:45 PM
  5. Can someone help me with Japanese?
    By Pistonwash in forum Yamaha PWC Performance (2-stroke)
    Replies: 19
    Last Post: 12-25-2005, 09:35 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •