Thread: Supercharger shaft o-ring?
01-19-2008, 10:22 AM #1
Supercharger shaft o-ring?
I have searched for the last hour but can't seem to find the answer to my question. I am about to reinstall my buddies blower but first I am replacing the o-rings. I remember one being bigger than the other or something like that. Just want to make sure I put the new ones on right if anyone could help. I feel stupid because I just did 2 last summer but I can't seem remember how it goes to save my life. Thanks.
01-19-2008, 10:29 AM #2
There are three O rings on a supercharger. Two go on the shank where the SC fits into the engine block. They are the same size.
The third O ring fits on the supercharger shaft and is behind the impeller. This is a little small O ring.
01-19-2008, 10:40 AM #3
Thanks Jerry. For some reason I thought one was thicker than the other on the shaft or something like that.
01-19-2008, 10:53 AM #4
are you referring to the clutch washers or the o-rings?
something tells me u know what u r asking, just using wrong terminology...
the clutch washers are different, but they only fit on one way so u can't screw it up
01-19-2008, 11:07 AM #5
Good catch Shibby.
The clutch washers have one hole that is larger than the other. They will only go on one way so you can't go wrong
01-19-2008, 11:14 AM #6
I was referring to the two o-rings on the end of the shaft where the blower enters the block. Thanks for the elp guys.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By gtoconv in forum 4-Tec PerformanceReplies: 4Last Post: 01-25-2008, 12:56 PM
By PropOrJet in forum Sea Doo Open DiscussionReplies: 3Last Post: 07-14-2007, 01:23 PM
By 1FastTrespiper in forum 4-Tec PerformanceReplies: 9Last Post: 04-29-2007, 01:48 PM
By RXP04 in forum 4-Tec PerformanceReplies: 14Last Post: 04-16-2007, 12:07 PM
By Sundance in forum 4-Tec PerformanceReplies: 3Last Post: 11-10-2006, 09:50 AM