Thread: 2004 supercharger shaft
01-25-2008, 09:14 AM #1
- Join Date
- Oct 2006
- wichita ks
2004 supercharger shaft
I have a 2004 rxp with 198 hours on it. I need to rebuild my supercharger 136 hours of it were stock. 60 hours of it was with a riva vortex SC wheel and metal clutch washer.
the last two hours were with the rotaxracing wheel
Is it safe/ok to use the 04 set up with the rotaxracing wheel as long as I have the metal clutch washers and ceramic bearings ?
01-25-2008, 10:44 AM #2
Yes, you can use the 04-05 shaft, but at those hours, I would replace bearings, gear, spring washers and clutch washers. Since you should do all that, you might as well upgrade to the bigger shaft.
01-25-2008, 10:58 AM #3
The shaft and teeth on the gears wear down quickly. Mine at 100+ hours looked horrible. I would highly recommend a complete rebuild. I would also highly recommend you have Jerry do it. (he just did mine)
The S/C causes major damage, heartache, downtime, when something breaks in it.
01-25-2008, 12:48 PM #4
01-25-2008, 12:56 PM #5
- Join Date
- Nov 2007
- Odessa, TX
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By XPChris in forum Sea Doo Open DiscussionReplies: 4Last Post: 04-08-2008, 09:56 PM
By Suthrn in forum 4-Tec PerformanceReplies: 5Last Post: 01-19-2008, 11:14 AM
By 1FastTrespiper in forum 4-Tec PerformanceReplies: 9Last Post: 04-29-2007, 01:48 PM
By RXP04 in forum 4-Tec PerformanceReplies: 14Last Post: 04-16-2007, 12:07 PM
By Sundance in forum 4-Tec PerformanceReplies: 3Last Post: 11-10-2006, 09:50 AM