Thread: Intake Grate mod...
01-31-2008, 01:19 PM #1
Intake Grate mod...
I use the performer R&D kit but i don't have a good top speed i think is about the intake grate R&D, i cut 0,5mm on the left and right wings to decrease drag...
Do you think, i can throw this wings like the intake grate TBM for ULTRA ?
The 15f is lighter than ultra, in rought water intake grate help a lot but i think it's too agressive for a stock motor... I don't like to use stock intake grate, it's best for flat water but with R&D ride plate... very bad in rought water
01-31-2008, 05:27 PM #2
I too HAD R&D intake on my 15F. Its a DOG on the ski. I recently took it off, and noticed a very good speed increase. ~2MPH....
I might try cutting the center bar out of the stock intake, and see what that does.
Not sure about the TBM. Dunno if the hole pattern is the same.
02-01-2008, 02:54 PM #3
Yes, the stock intake grate is teh best for speed ! more of US rider's use watercraft in flat water, but me i ride in offshore...
TBM have a intake for ultralike this :
For a 15f, i seach is it's possible to do same things
Last edited by hsdforever; 02-01-2008 at 02:56 PM.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By ramnj in forum 4-Tec PerformanceReplies: 55Last Post: 10-11-2012, 01:47 PM
By elviswongg in forum Kawasaki PWC Performance (4-stroke)Replies: 16Last Post: 05-04-2009, 11:24 PM
By yami_rida#26 in forum Yamaha PWC Performance (2-stroke)Replies: 2Last Post: 03-03-2008, 07:23 PM
By turbodave in forum Kawasaki PWC Performance (4-stroke)Replies: 3Last Post: 07-29-2007, 07:11 PM
By yellow4 in forum 4-Tec PerformanceReplies: 2Last Post: 06-15-2007, 11:15 AM