Thread: MOST LIKELY A STUPID QUESTION
05-11-2006, 11:09 AM #1
MOST LIKELY A STUPID QUESTION
I was sittin here thinking why do you have to eliminate the internal Inner Cooler when adding the External power cooler, would it be to restrictive or maybe there would not be enough water flow to be feeding both. I havent installed my external one yet maybe when I do then reasons will become obvious.
05-11-2006, 11:20 AM #2
- Join Date
- May 2005
- Bristol, WI
The stock inner cooler appears to be very resrictive. I wouldn't run it with an external cooler.
05-11-2006, 11:23 AM #3
well that was some of my thinking ....but if it is an added benefit with the stock boost would the higher boost SC impellers maybe make the added restriction to extra cooling a mute point?
05-11-2006, 12:33 PM #4
Hmmmmm....... maybe it WAS a dumb question..........or your all holdin out on me....
05-11-2006, 02:31 PM #5
No questions are dumb...These guys will answer you, just give them a chance I dont know or I would give you my input...
05-11-2006, 03:08 PM #6
Its been tried before. It KILLS performance as intercoolers are restrictive devices. Putting two of them in the mix kills air speed thus reducing performance.
The stock SC is extremely restrictive. In fact, when switching from the stock IC to the Riva IC i noted a 1 psi improvement with the stock SC impeller.
05-11-2006, 03:15 PM #7
Ahh... Thanks i figured it had been tried so no need to waste time on it
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By JordieS in forum Yamaha ECU SupportReplies: 11Last Post: 12-15-2010, 05:08 PM
By Lvnspeed in forum Yamaha PWC Performance (2-stroke)Replies: 10Last Post: 08-26-2006, 12:39 PM
By RTEdgar in forum Sea Doo Open DiscussionReplies: 11Last Post: 07-25-2006, 08:11 PM
By N8R in forum Yamaha Open DiscussionReplies: 9Last Post: 07-18-2006, 10:07 PM
By RustySeaRustyDoo in forum Sea Doo Open DiscussionReplies: 13Last Post: 11-17-2005, 01:40 AM