Thread: Hole size for Rude exhaust tip?
02-02-2008, 07:52 PM #1
Hole size for Rude exhaust tip?
What size hole are you guys drilling to install the Rude exhaust tip? Seems like a 2 3/4 hole saw would make the best fit. Just wanna make sure befor I do it. Thanks
02-02-2008, 07:56 PM #2
02-02-2008, 08:02 PM #3
Cool beans thanks for the quick response
02-02-2008, 09:48 PM #4
I used a 2 and 3/4 and then had to use dremel to make tip fit. It is a good way cause the hole bit can leave it a little rough, and then with dremel it really did nice job on the finish. It does not take much with dremel so do not make the hole much bigger. just sand down the fiberglass and you will be good. I used alot of silicone to fill in any gaps.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Joe Stang in forum Sea Doo ClassifiedsReplies: 5Last Post: 04-24-2013, 08:55 AM
By RobWCanada in forum 4-Tec PerformanceReplies: 12Last Post: 05-12-2011, 09:35 PM
By KeithKman in forum 4-Tec PerformanceReplies: 21Last Post: 07-18-2009, 01:14 AM
By mstennes in forum 4-Tec PerformanceReplies: 27Last Post: 12-04-2007, 07:44 PM
By lbmacjr2005 in forum 4-Tec PerformanceReplies: 1Last Post: 07-31-2007, 03:12 PM