Thread: PTO shroud remove
02-04-2008, 05:42 AM #1
- Join Date
- Jan 2008
PTO shroud remove
How I can remove the PTO shroud of 1995 Polaris 750?
02-04-2008, 09:46 AM #2
Just remove the 2 hose clamps on it and pull it off, if you rotate it you can see its not a complete piece and can be taken off the shaft w/o disconnecting the motor from the pump.
Wear some gloves, mine was full of grease and dirt.
Post back if you need more help.
Welcome to the forums, lots of real cool doods in here that can help with most any question you have.
Last edited by swimmerjaxon; 02-04-2008 at 10:41 AM. Reason: Rude not to welcome to the forums
02-04-2008, 10:06 AM #3
WELCOME to the Green Hulk Forums!!!
My 750 has one clamp. I just loosen the clamp and slide it out of the way. I then give a very hard tug on the larger end.
Great tip about the glove!!
02-04-2008, 10:57 AM #4
Don't forget to put it back on when you are done... it keeps the driveline from throwing water up toward the carbs.
02-04-2008, 11:28 AM #5
- Join Date
- Aug 2006
and it prevents twisting loose wires /hoses around the shaft
02-04-2008, 04:52 PM #6
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By cool34 in forum Sea Doo How To & FAQsReplies: 1Last Post: 05-17-2013, 09:29 PM
By addicted in forum 4-Tec PerformanceReplies: 20Last Post: 11-15-2011, 02:14 PM
By lt1transam in forum 2-Stroke PerformanceReplies: 7Last Post: 03-06-2009, 08:03 AM
By bnovak in forum Yamaha PWC Performance (2-stroke)Replies: 4Last Post: 09-20-2007, 07:30 PM
By Lurker in forum 4-Tec PerformanceReplies: 19Last Post: 07-14-2007, 09:11 AM