Thread: XS Intercooler Piping
02-10-2008, 02:57 PM #1
XS Intercooler Piping
I am in the process of gathering all the material for XS intercooler install. How long should the 2.5" tubing be?
02-10-2008, 03:48 PM #2
I'm not one to recommend the XS IC but........
here you go.........
02-10-2008, 03:53 PM #3
Six to eight inches, you do not want them to be to long. Less volume your SC has to fill to get max boost. To much pipe will cause lag.
02-11-2008, 06:11 PM #4
I just got my XS (Ebay) Intercooler today, damn this thing is huge and heavy. However, the intercooler has a threaded hole over one of the water caps, I am guessing it's an air bleed hole or something.
02-11-2008, 06:39 PM #5
no mounting whole they are. if you dont use both plug one you will lose boost
02-11-2008, 07:12 PM #6
There is only 1 hole and it's located on one of the water end housing. If it's a mounting then is in a odd place.
I would post a pic but I can not find my camera's usb cable.
02-11-2008, 08:03 PM #7
With the ic setting flat on the floor. You should have two small mounting holes on the side and and water inlet on the front and back and 2 3in air inlets on the front.
02-11-2008, 08:27 PM #8
02-12-2008, 07:44 AM #9
Its an alternate water inlet/outlet. Plug it or use it.
02-12-2008, 10:43 AM #10
I was looking on ebay at the intercoolers and I saw some that did not have the mounting holes on the sides. Looks like you got one of those.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By STSPERFORMANCE in forum 4-Tec PerformanceReplies: 23Last Post: 10-13-2008, 11:00 AM
By camar0 in forum Sea Doo ClassifiedsReplies: 0Last Post: 09-05-2008, 01:27 AM
By kp04rxp in forum Sea Doo ClassifiedsReplies: 10Last Post: 05-29-2008, 08:20 AM
By codymouse54321 in forum 4-Tec PerformanceReplies: 8Last Post: 07-13-2007, 04:49 PM
By excess in forum 4-Tec PerformanceReplies: 13Last Post: 06-11-2006, 11:03 AM