Thread: ride plate, nitrous
03-08-2008, 05:52 PM #1
- Join Date
- Jan 2008
- Clermont FL.
ride plate, nitrous
I am going to smooth my ride plate. What is used most times to fill the holes. Is this the only thing that is done to the ride plate. I also saw on ebay someone is tring to sell a nitrous kit for skis. have experience with this and cars but this is the first time to see it mentioned for skis.
03-08-2008, 07:15 PM #2
Welcome to the HULK!!!! Lots of things can be used to fill the holes.. Start with a little rope and duct tape, (makes getting it back off possible). You can use just about any epoxy to fill/smooth it out.
03-08-2008, 07:17 PM #3
As far as NOS... This is a loaded subject. I honestly belive it is not a good way to go on PWC's. As to get the most out of it you will need to run a diffrent pitch prop. So when you are not using the NOS your PWC will run worse than before. OR you would be constantly changing out impellers.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By ActionR32 in forum 4-Tec PerformanceReplies: 14Last Post: 12-26-2005, 02:31 PM
By nitro rxp in forum 4-Tec PerformanceReplies: 3Last Post: 08-13-2005, 01:00 PM
By 01xdime in forum 4-Tec PerformanceReplies: 8Last Post: 08-11-2005, 02:43 PM
By SKR8PN in forum 4-Tec PerformanceReplies: 26Last Post: 07-01-2005, 11:56 AM
By Krazy-K in forum 4-Tec PerformanceReplies: 8Last Post: 06-21-2005, 05:10 PM