03-11-2008, 04:38 PM #1
Made an ooops when setting up pissers
I didnt take into consideration for the flush kit. Were should I T into?
03-11-2008, 04:44 PM #2
- Join Date
- Aug 2006
in the water bar ?
03-11-2008, 05:43 PM #3
03-11-2008, 05:44 PM #4
I'm thinking his water bar is gone to get pissers off the heads. T into the water line from the pump? Seems you would need to valve off the pump side when running on the hose. Path of least resistance would push the water out the pump if a valve wasn't installed.
03-11-2008, 05:47 PM #5
Valve installed!!!! Water from pump passes through strainer, then valve, then into engine.... Hook up hose and close valve, water will go through the engine and not out the pump. But you gotta make sure you open it up before going riding... It will also allow you to close it off, just in case you need a tow.
03-11-2008, 07:06 PM #6
You can also get one of these, they work KILLER. You can get them in 1 or 3 outlet and they just push into the pisser outlet. I like them because it flows the opposite direction and hopefully gets the sand, dirt, salt etc. that gets missed while continually flowing one direction.
Back Flush Tool
03-11-2008, 08:47 PM #7
03-12-2008, 06:07 AM #8
03-12-2008, 08:21 PM #9
03-12-2008, 08:23 PM #10
Plus with restrictors in the lines, how is this going to get water flowin through efficently?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By xlint89 in forum Polaris Open DiscussionReplies: 65Last Post: 07-17-2010, 11:02 AM
By amf133 in forum Yamaha How To & FAQsReplies: 1Last Post: 03-30-2010, 01:51 PM
By dirtdude35 in forum Polaris Open DiscussionReplies: 36Last Post: 12-19-2009, 02:42 PM
By Dockside in forum 4-Tec PerformanceReplies: 22Last Post: 12-19-2009, 12:20 PM
By mkulczyckyj in forum Polaris How To & FAQsReplies: 5Last Post: 06-19-2009, 11:30 AM