Thread: Testing Oil Pump
03-21-2008, 12:47 PM #1
Testing Oil Pump
I had decided to say screw testing the oil pump because I was going to take the bet it was fine. Decided today before finishing up to undo it and check it. I put it on the end of a drill and spin it while I hold the lever wot. The oil flows out but my question is how fast should it flow? All lines flow the same. Anyway to make sure its good?
The ski only have 45 hours ish so I bet it is fine but I would rather be safe than sorry.
Ps. The drill only spins at 1500 rpms. So I bet I am good to go if it is pumping with that.
Last edited by Chrisrokc; 03-21-2008 at 12:49 PM.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By heebeha in forum Polaris Open DiscussionReplies: 16Last Post: 06-19-2012, 08:08 AM
By Steveard in forum Yamaha PWC Performance (2-stroke)Replies: 0Last Post: 12-12-2010, 07:07 PM
By 951ccshoe04 in forum Yamaha How To & FAQsReplies: 3Last Post: 01-10-2010, 10:39 PM
By bnovak in forum Polaris How To & FAQsReplies: 2Last Post: 05-28-2009, 07:32 PM
By MNAPR in forum Yamaha How To & FAQsReplies: 10Last Post: 02-15-2008, 07:17 AM