Thread: Smoothing out my RXP hull.
03-31-2008, 09:59 AM #1
Smoothing out my RXP hull.
I have been reading quite a few posts on here to learn just about everything there is to know about these skis.
Yesterday I finally built up the courage to remove the pump. HOW EASY! I'm going to try Dans method of applying epoxy to the wear ring and smooth it out until I can afford to grab an SS wear ring.
I was cutting off a crap load of excess blobs of black (silicon?) Sea-doo uses to seal the pump shoe on to the hull. Boy do they do a messy job. What do you guys use to fill these crevices that were under applied? Is it really black silicone? I wan't to make the entrance as smooth as can be.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By PAUL SERPICO in forum Sea Doo ClassifiedsReplies: 31Last Post: 03-04-2015, 09:37 AM
FS - Parts FS: 05 black/ green RXP hull or part outBy Boosted3s in forum Sea Doo ClassifiedsReplies: 3Last Post: 07-29-2012, 06:55 PM
By SeadooTech in forum Sea Doo ClassifiedsReplies: 1Last Post: 08-24-2011, 01:43 PM
By wegot2hulkx in forum Sea Doo Open DiscussionReplies: 3Last Post: 02-22-2008, 11:30 PM
By MikeTrin in forum Videos & PicturesReplies: 36Last Post: 04-16-2006, 04:58 PM