Thread: Must do $25 mod for GTX/RXT
06-01-2006, 04:12 PM #1
Must do $25 mod for GTX/RXT
Block off your OPAS distributor.
Call PPG and ask for the miscellaneous Seadoo part for the OPAS.
It's like 25 dollars shipped.
It's the cover and a gasket. I used a bolt and nut and widened the hole a little for the larger bolt. Then used right stuff gasket. On the bolt I used red loctite and then jb weld over it. Just to make it permanent.
If you don't you will eventually knock it loose and end up with a 3" hole.
It happened to Mrbriddle too
I've heard a couple others also
Here is my sinking story.
06-01-2006, 04:17 PM #2
If you get the PPG kit from the start, it comes with this plate.
06-03-2006, 01:54 AM #3
- Join Date
- Aug 2005
- Jerry's guest bedroom
So they charge $25 for a piece of stamped metal? Whats that, $24 profit? I'm in the wrong business.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Good2Go16 in forum Sea Doo ClassifiedsReplies: 6Last Post: 01-01-2010, 11:54 AM
WTB UMI for GTX/RXTBy k-man-kid in forum Sea Doo ClassifiedsReplies: 0Last Post: 12-13-2009, 11:46 PM
By Sosa62 in forum Sea Doo Open DiscussionReplies: 2Last Post: 06-04-2007, 04:39 PM
By KsharK in forum 4-Tec PerformanceReplies: 9Last Post: 06-20-2006, 12:01 AM
By Green Hulk in forum 4-Tec PerformanceReplies: 7Last Post: 06-14-2006, 07:25 PM