Thread: another bendix Q
04-02-2008, 04:18 PM #1
another bendix Q
Guys ive searched but cant find another yami with quite the same problem so here goes...
hit the starter on jump(gpr13) and the starter spins free but bendix will not engage...
but if i remove the plugs in all three the bendix kicks in and she spins great and turns over..
battery 100% ok...
and as far as i can remember bendix has two washers one each side of new spring...
can anybody put there finger on this or is it as i suspect the bendix gone bad
04-02-2008, 05:12 PM #2
just got the sucker out and thought i would snap a quick one for you to see..
would the surface rust effect its working i thought not on the rebuild but replaced the weight spring and c clip and inspected the lot and all seemed good..
04-02-2008, 05:23 PM #3
Sounds like its not engaging all the way.
Spring and washer in the mag cover?? Thin washer on the back side of the bendix??
04-02-2008, 05:37 PM #4
Last edited by Hydrotherapy; 04-02-2008 at 05:43 PM.
04-02-2008, 05:59 PM #5
04-02-2008, 06:01 PM #6
04-02-2008, 06:04 PM #7
04-02-2008, 06:09 PM #8
04-02-2008, 06:17 PM #9
04-02-2008, 06:18 PM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Denali44 in forum 4-Tec PerformanceReplies: 5Last Post: 08-08-2005, 04:31 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 13Last Post: 07-04-2005, 12:50 PM
By rx4pain in forum 4-Tec PerformanceReplies: 6Last Post: 06-30-2005, 10:00 PM
By Jeff C in forum Sea Doo Open DiscussionReplies: 1Last Post: 05-29-2005, 11:55 PM
By Gforce in forum 4-Tec PerformanceReplies: 5Last Post: 05-03-2005, 09:48 PM