04-03-2008, 02:18 AM #1
Correct Bolt Sizes and Washers For Intake Grates
Guys so much as been said about these 800 grates breaking so on i read in a earlier post WFO saying long bolts in the front short in the rear with washer
Can someone or WFO lets us know the correct sizes and what washer flat washer or a spring washer or both.
I have 30mm in the front with a flat washer and in the rear i have 20mm with a flat washer is this correct
04-04-2008, 02:49 AM #2
04-04-2008, 07:12 AM #3
Those are the correct bolts and right location Mike.
04-04-2008, 12:20 PM #4
I usually dont use the washers in the rear as it makes the bolt hang down below the grate.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By bksbigboy69 in forum Sea Doo ClassifiedsReplies: 0Last Post: 10-23-2011, 08:07 PM
By Johnny5 in forum Yamaha ClassifiedsReplies: 1Last Post: 11-02-2010, 05:07 PM
By Quicky in forum Yamaha PWC Performance (2-stroke)Replies: 0Last Post: 08-11-2010, 09:03 PM
By TampaSpeedster in forum 4-Tec PerformanceReplies: 10Last Post: 04-15-2010, 07:20 AM
By scittb in forum Yamaha ClassifiedsReplies: 8Last Post: 04-20-2009, 10:53 PM