Results 1 to 1 of 1
  1. #1
    DaveC's Avatar
    Join Date
    Jun 2007
    Central Oklahoma

    Pump support alignment tips ?

    Does anyone else have any helpful tips for alignment of the pump support on the RXPs ? The original support had 3 shims on the lower left and 1 shim on the lower right, of course the new pump support is not close with this setup. After several attempts with the alignment tool and getting to where it is close, I notice that the alignment shaft is to the left ( as looking from the rear of the ski) and is off center.

    If anyone has any ideas that would be great.


    Got it, a lot easier than it looked.
    Last edited by DaveC; 04-06-2008 at 11:58 PM.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. (Damaged) Pump Support Question
    By Snoman in forum 4-Tec Performance
    Replies: 6
    Last Post: 04-13-2006, 06:37 AM
  2. Time for a new pump support
    By Mark S in forum 4-Tec Performance
    Replies: 5
    Last Post: 04-11-2006, 10:46 PM
  3. do pump support fins have any purpose
    By macattack in forum 4-Tec Performance
    Replies: 17
    Last Post: 07-10-2005, 09:56 PM
  4. Are sharks plastic fins in the pump support needed
    By macattack in forum 4-Tec Performance
    Replies: 0
    Last Post: 07-04-2005, 11:50 AM
  5. pump support replacement
    By zoom zoom in forum 4-Tec Performance
    Replies: 7
    Last Post: 07-03-2005, 10:17 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts