04-08-2008, 11:16 AM #1
Tips on removing stock oil pressure jet???
I'm instaling the RR oil pressure jet, I've removed the plastic and ball bearing just cant get the casing out.
I haven't got a dent puller, will getting something thin between the casing and the block (small flat screwdriver) and collapsing it in on itself work?
04-08-2008, 11:35 AM #2
04-08-2008, 12:01 PM #3
No, its wedged in there, I've tried putting a self tapping screw into the hole in the bottom of the casing and pulling but its not moving
04-08-2008, 12:15 PM #4
I actually threaded a tap into the casing once I removed the plastic and ball bearing....gave it a little twist and yanked it right out....
Done a few this way with no apparent problems...
04-08-2008, 12:41 PM #5
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Green Hulk in forum Sea Doo How To & FAQsReplies: 22Last Post: 06-21-2014, 02:15 PM
By SJL Custom in forum 4-Tec PerformanceReplies: 13Last Post: 03-13-2012, 05:57 PM
By beachboy66 in forum 4-Tec PerformanceReplies: 4Last Post: 07-21-2006, 04:21 PM
By excess in forum 4-Tec PerformanceReplies: 12Last Post: 07-01-2006, 10:02 AM
By excess in forum 4-Tec PerformanceReplies: 10Last Post: 05-31-2006, 09:50 PM