Thread: drive shaft
04-09-2008, 11:39 PM #1
- Join Date
- Mar 2008
was wondering if the drive shaft on a041300gpr screws into front of impeller or is mine just seized in there.
04-09-2008, 11:44 PM #2
The driveshaft is pressed into the pump bearings, and the prop left-hand screws onto the driveshaft.
04-09-2008, 11:45 PM #3
My GP1200 the impeller slides down the shaft and screws on in front of the pump stator I bet yours does too.
04-10-2008, 07:25 AM #4
04-10-2008, 08:31 AM #5
When you drop the prop on the shaft, does it spin counter-clockwise to tighten?
04-10-2008, 08:42 AM #6
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By CarFanatic in forum 4-Tec PerformanceReplies: 5Last Post: 08-06-2006, 02:13 AM
By hitman in forum Yamaha PWC Performance (2-stroke)Replies: 6Last Post: 08-01-2006, 10:23 PM
By 1FastTrespiper in forum Sea Doo Open DiscussionReplies: 6Last Post: 07-17-2006, 10:47 PM
By chuck in forum Yamaha PWC Performance (2-stroke)Replies: 2Last Post: 02-20-2006, 08:37 AM
By dewsy in forum 4-Tec PerformanceReplies: 4Last Post: 01-26-2006, 07:47 AM