Thread: Reverse bucket question?
04-10-2008, 09:19 AM #1
Reverse bucket question?
My reverse bucket appears to be awfully close to the pump nozzle. Can the bucket be adjusted to go higher above the pump nozzle. It is not below the nozzle but almost, maybe a 1/8" above it. This may be ok, I am just not sure.
04-10-2008, 07:46 PM #2
I trimmed the little lip that sticks down a little bit, the 2 " part that sticks down and out.Donno if it did any good, just looked a little to close for me.
04-10-2008, 07:47 PM #3
- Join Date
- Jan 2007
04-10-2008, 08:55 PM #4
04-11-2008, 11:21 AM #5
Thanks guys, I am just affraid if it were to drop down any at all the jet stream would hit and tear something up. Sounds like I just need to get the hack saw out to be safe.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By gmoeller in forum Kawasaki How To & FAQsReplies: 9Last Post: 01-10-2012, 08:29 PM
By iceman1998 in forum 4-Tec PerformanceReplies: 10Last Post: 07-15-2010, 09:38 AM
By Toobold in forum Yamaha PWC Performance (4-stroke)Replies: 3Last Post: 06-21-2010, 12:47 PM
By RXP85 in forum Sea Doo Open DiscussionReplies: 7Last Post: 04-16-2010, 12:59 AM
By watermedic in forum 4-Tec PerformanceReplies: 33Last Post: 08-22-2005, 04:23 PM