Thread: What size hole saw?
04-10-2008, 11:22 AM #1
What size hole saw?
Can anyone tell me what size hole saw i need for the 2 inch flo-rites that Jerry sells in his store?
04-10-2008, 11:51 AM #2
i used 2-1/8 i think and then used a round file to get them really tight.
04-10-2008, 11:58 AM #3
I don think that will work, I have a 2 3/8, I test drilled a hole in some cardboard and it looks far too tight for the flo-rite.
04-10-2008, 12:08 PM #4
If i remember correctly it's 2 3/8
04-10-2008, 12:09 PM #5
04-10-2008, 12:17 PM #6
The width of the hull is toot tight for the clips, break them off and the 2 3/8 works fine with some silicon, got there in the end! Thanks
04-10-2008, 03:15 PM #7
- Join Date
- Nov 2007
- doncaster. UK
you'll have to post a video grant when you've finshed it mate
04-10-2008, 05:35 PM #8
yeah, sorry it was 2-3/8 and i still had to open it up more to fit
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By tacomaguy00 in forum 4-Tec PerformanceReplies: 7Last Post: 02-14-2013, 08:13 AM
By addicted in forum 4-Tec PerformanceReplies: 9Last Post: 01-25-2011, 05:34 PM
By scottslayr in forum Yamaha PWC Performance (2-stroke)Replies: 6Last Post: 09-02-2010, 05:46 PM
By bruinsrme in forum 4-Tec PerformanceReplies: 7Last Post: 05-27-2008, 08:00 PM
By mstennes in forum 4-Tec PerformanceReplies: 27Last Post: 12-04-2007, 07:44 PM