Thread: Tunnel reinforcement & D-Plate
04-21-2008, 04:35 AM #1
Tunnel reinforcement & D-Plate
When I have my exhaust out to do my tunnel reinforcement on my '05 GPR, I would like to throw the D-Plate in just for reliability purposes. (no need to wait for the cat-con to fail)
My question is, when doing just the D-Plate, will the EFI Controller be needed to add more fuel, or is it not needed for just the D-Plate?
I have zero other engine mods now. The only thing that I've really done is the standard issue air mods, (bucket, hood and seat) PPK, 800 Grate and stepped sponsons.
04-21-2008, 08:38 AM #2
no controller needed for just the d-plate
04-21-2008, 11:29 AM #3
Thanks Rich.... I was going to call ya later if I didn't get a response.
Is the R&D D-Plate still the plate of choice and will I need ANY new gaskets to do this??
04-21-2008, 11:31 AM #4
04-21-2008, 11:36 AM #5
04-21-2008, 01:54 PM #6
04-21-2008, 01:56 PM #7
04-21-2008, 01:58 PM #8
i looked at the riva installation instructions for the d-plate and i know it's in the stinger pipe but i don't know exactly where and how i should install it. Sorry for the dumb questions guys..but can someone chime in on this please
04-21-2008, 03:33 PM #9
04-21-2008, 03:57 PM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Pistonwash in forum Yamaha How To & FAQsReplies: 229Last Post: 11-29-2013, 12:13 PM
By O-ToWn1300R in forum Yamaha PWC Performance (2-stroke)Replies: 6Last Post: 04-26-2006, 11:32 AM
By elebouef in forum Yamaha PWC Performance (2-stroke)Replies: 5Last Post: 04-17-2006, 10:52 PM
By Vern in forum 4-Tec PerformanceReplies: 11Last Post: 01-30-2006, 05:34 PM
By ABBOTT in forum Yamaha How To & FAQsReplies: 13Last Post: 01-08-2006, 11:41 AM