Thread: rear exhasut cutout template??
04-21-2008, 06:36 PM #1
rear exhasut cutout template??
i found the riva instructions in the how too section.
any special printing instructions, as far as scale of printout, etc??
its a pdf document.
i can print, just want to make sure it prints correct size etc.
use "fit to margin"
or no margin??
no margin, prints a little bigger...
04-21-2008, 07:35 PM #2
print each one out and measure the big hole, should be somewhere aroundthe size stated on the sheet.
04-21-2008, 08:12 PM #3
yep that makes sense, it was the larger printout
margins set to "none"
04-21-2008, 08:47 PM #4
I just did mine last night Lex. What tip are you using? If you have to sand the hole a little bigger with a dremel just take your time.
04-21-2008, 10:40 PM #5
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Lakeside518 in forum Yamaha PWC Performance (4-stroke)Replies: 4Last Post: 03-09-2013, 09:32 AM
By NOONZ in forum 4-Tec PerformanceReplies: 7Last Post: 11-23-2010, 09:07 PM
By mvanarchy in forum Sea Doo ClassifiedsReplies: 4Last Post: 07-05-2008, 02:49 PM
By camar0 in forum 4-Tec PerformanceReplies: 19Last Post: 12-04-2007, 08:14 PM
By Kinchyle in forum 4-Tec PerformanceReplies: 5Last Post: 08-02-2005, 12:41 PM