Thread: Ultra 150 ada head question
05-01-2008, 12:20 PM #1
Ultra 150 ada head question
Does anyone remember the torque specs for the one piece? I got my ski running and I have a little water comming out from under a head bolt. So I need to reset o-rings and try again.
05-01-2008, 06:17 PM #2
22ft lbs or 69in lbs is for stock. Not sure if ADA requires a differant tourque spec.
Is this the first time you have used the head or have you been running it and what was the gain....I assume bottom of course but anywhere else that was very noticeable...thanks
05-01-2008, 07:40 PM #3
Should be 22 ft lbs. I run skiworx heads and thats what they call for ada should be the same. At arround 30 ft lb the studs will break
05-02-2008, 07:49 AM #4
05-03-2008, 10:02 AM #5
69 in lbs is the initial torque then go back and tighten to 22 ft lbs.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By camcama in forum Kawasaki ClassifiedsReplies: 4Last Post: 04-29-2014, 10:56 PM
By kaarona1 in forum Yamaha PWC Performance (2-stroke)Replies: 15Last Post: 06-20-2009, 11:17 PM
By slag in forum Kawasaki How To & FAQsReplies: 9Last Post: 08-24-2008, 12:35 PM
By Mack77 in forum Kawasaki ClassifiedsReplies: 0Last Post: 08-10-2008, 06:07 PM
By jcc011185 in forum Kawasaki Open DiscussionReplies: 10Last Post: 07-31-2007, 07:26 PM