06-14-2006, 11:18 AM #1
antone running the dynotune boost gauge ..question 4 u
Do u get any readings on the trailer??? mine stays at .0.05 no matter what ... i would think that it should atleast move with vaccum???
06-14-2006, 12:02 PM #2
I ran mine on the trailer and got messed up readings too. I haven't had a chance to run it in the water cause I still need to pick up the mirror mount from Shibby. Shibby said that it fixes itself after running in the water for a few though so you should be ok. Let me know how you make out though....
06-14-2006, 12:35 PM #3
06-14-2006, 01:18 PM #4
you wont get any boost readings until you get out on the water.
06-14-2006, 02:12 PM #5
ill take ur word jerry , raining up here bad its gonna be a few days until i get it out ... shouldnt i see some movement on the gauge tho???
06-14-2006, 02:18 PM #6
I see vacuum movement on mine while at idle and i gun the throttle. Never reaches into boost readings though.
06-14-2006, 03:54 PM #7
ok then i think there is something wrong with this gauge its just reading the same on the trailer no matter what
06-14-2006, 05:59 PM #8Originally Posted by CRAZEDRXP
disconnect the plug from the sender and the harness, disconnect the power, plug it all back togethger, and it will be fine... my froze up once bc i accidentally left it on overnight jsut disconnected eveyrhting, plugged it back in and it was fine. believe it was .05 actually that it froze at.
like jerry said... forget the trailer readings... turn it off, and worry about it when u hit the water when u r under load.
06-14-2006, 06:50 PM #9
do you have your gauge running straight to the battery? u have an inline fuse? a switched power source?
Yes .... ok ill wait until wheather clears up
06-14-2006, 08:07 PM #10
i dunt really know, lololol. i had a realy sloppy quick jig setup jsut so i could test it oneday. i use the aligator clips from my battery tender charger and taped crap together all over, just so happens i had a fuse in there somehow...
i dont have the directions anymore... did it recommend running an inline fuse for the gauge?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By RxPrider in forum 4-Tec PerformanceReplies: 8Last Post: 02-26-2007, 04:42 AM
By meirvin in forum 4-Tec PerformanceReplies: 2Last Post: 01-18-2007, 11:41 PM
By CarFanatic in forum 4-Tec PerformanceReplies: 25Last Post: 07-11-2006, 11:05 AM
By CRAZEDRXP in forum Sea Doo Open DiscussionReplies: 8Last Post: 06-08-2006, 02:44 PM
By Water4fire in forum 4-Tec PerformanceReplies: 6Last Post: 05-15-2006, 12:07 AM