05-04-2008, 09:55 PM #1
RRFPR and boost gauge tap block off
In looking at the RRFPR I assume I am tapping off the IC Block off.
Do I have to tap a hole in the IC block off or can I split the output on the IC block off and send one to the RRFPR and the other to the boost gauge?
05-04-2008, 10:01 PM #2
05-04-2008, 10:03 PM #3
would you happen to have a pict where you tapped the intake?
05-04-2008, 10:26 PM #4
I would just remove the blockoff and tap next to your boost gauge, you will get the same reading. What size of tubing comes with the regulator, for the boost reference?
05-04-2008, 10:39 PM #5
05-04-2008, 11:23 PM #6
So I cant just put a T on the block off? I have to drill and tap it for another nipple when I install my FPR?
05-05-2008, 12:26 AM #7
I am hoping you can just use a T... thats what I am planning on doing.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By jtskier11 in forum Sea Doo ClassifiedsReplies: 9Last Post: 08-13-2010, 09:17 AM
By rxtmike in forum Sea Doo ClassifiedsReplies: 2Last Post: 05-30-2010, 08:04 AM
By RXPRacer513 in forum Sea Doo ClassifiedsReplies: 6Last Post: 10-04-2009, 04:17 PM
By apactorpedo in forum 4-Tec PerformanceReplies: 2Last Post: 02-14-2007, 07:01 PM
By HOSS in forum 4-Tec PerformanceReplies: 12Last Post: 09-10-2006, 07:23 AM