Thread: RRFPR Install questions
05-11-2008, 11:09 AM #1
RRFPR Install questions
Ok things went relative smoothly (after I got over the intimdation factor)
Question 1 The RRF is in and secured down. I can move it very eaily left to right. Is this normal?
Question 2 Should I tap another hole in the IC block off or Manifold.
If in the manifold where? (picts please)
1. There will be some gas spillage so get some rags to soak it up.
2. RXT skis pull the glove compartment access is real easy.
3. Cut the connector off as in the instructions, you have PLENTY of fuel line to work with.
I will have some picts later.
Last edited by bruinsrme; 05-11-2008 at 11:13 AM.
05-11-2008, 11:14 AM #2
Left to right movement is normal. The stock regulator moves too.
05-11-2008, 11:17 AM #3
Tap the stock ic blockoff or the intake manifold 1" above the MAP sensor
05-11-2008, 11:20 AM #4
Scotty, did you find the protusions on the intake manifold? The one toward the front of the ski, cylinder 3, is the one to tap into. It works fine and keeps the vacum hose out of the way of the boost guage, etc.
05-11-2008, 11:54 AM #5
Yeah I found it.
Installing the IC now. gonna stuff RXPblur in the hull.
be back in a while
thanks Larry and Jerry.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Vern in forum 4-Tec PerformanceReplies: 10Last Post: 04-01-2006, 01:26 PM
By TroyRXP15 in forum 4-Tec PerformanceReplies: 3Last Post: 08-15-2005, 09:16 PM
By Vern in forum 4-Tec PerformanceReplies: 11Last Post: 07-09-2005, 09:59 AM
By Mark S in forum 4-Tec PerformanceReplies: 2Last Post: 07-01-2005, 09:25 PM
By 05Limited in forum 4-Tec PerformanceReplies: 5Last Post: 06-03-2005, 09:54 AM