Thread: 95XP oil pump issues
05-24-2008, 05:46 PM #1
95XP oil pump issues
so last week i cleaned the carbs and added new fuel lines. at one point I dropped the carbs in the hull. no damage but i think that the oil supply line on the mag side got clipped. There is no damage to the pistons or case but I cant get the oil pump to pump oil up the new line that I installed. Any suggestions??
05-24-2008, 06:30 PM #2
What are you doing to pump it up ??
Is the engine running ???
05-24-2008, 07:19 PM #3
05-24-2008, 07:52 PM #4
05-25-2008, 09:21 AM #5
when I first changed the line I did for a bout two seconds when I realized that it wasnt pumping then quickly shut it down. I installed a clear line. I tried to pump it by just turning the motor by hand with out the plugs in and still nothing.
I would like to go premix but its not an option. I have other family that borrow them sometimes and cant trust them to mix it correctly.
05-25-2008, 10:39 AM #6
Premix fuel in tank,start engine,move oil pump arm to full open & the oil will start to pump.
Its not gonna do it by spinning the motor by hand.
05-25-2008, 12:18 PM #7
thanks worx. whats the premix ratio? Its going to smoke a lot with double the oil right?
05-25-2008, 03:40 PM #8
50-1 is fine for what your are doing,it may smoke a little more.
05-26-2008, 12:02 PM #9
Thanks for the help Dan, I got it working now. the only issue that i have now is a small air bubble at the barb that will not pass on the mag side. I tried pushing it through but it wont go...any ideas?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Mattw in forum Yamaha PWC Performance (2-stroke)Replies: 25Last Post: 03-06-2013, 09:47 PM
By guitar jeff in forum Polaris How To & FAQsReplies: 3Last Post: 05-16-2010, 07:14 PM
By mikerosi in forum Polaris Open DiscussionReplies: 14Last Post: 06-19-2008, 09:00 PM
By bic1 in forum 4-Tec PerformanceReplies: 3Last Post: 03-05-2006, 03:15 PM
By theantiRXP in forum Sea Doo How To & FAQsReplies: 2Last Post: 06-25-2005, 12:20 PM