Results 1 to 2 of 2
  1. #1
    CatRunner's Avatar
    Join Date
    May 2007
    Los Angeles, Sunny Calli

    5 Degree Nozzle Mods?

    What mods should I perform on my late `98 GP 1200 5 degree nozzle before I fit in onto my 1100 Raider? (I understand that I need to gps before and after fitting)

    I`m guessing fill the visibility water spout hole with jb-weld and cut that pipe off flush, there doesnt seem to be any casting marks to remove.

    Is there anything else that you recommend?



  2. #2

    Join Date
    Feb 2007
    Tampa, FL
    that pipe is the bilge so if you cut it make sure to block it off, otherwise it will pump water into the hull.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. WTB GP1200 5 Degree Nozzle
    By Adam E. in forum Yamaha Classifieds
    Replies: 7
    Last Post: 05-04-2010, 09:00 PM
  2. 0 or 5 degree nozzle
    By novaboy in forum Yamaha Old School Skis
    Replies: 25
    Last Post: 07-15-2009, 09:55 AM
  3. Ultra 1 degree nozzle wedge r&d
    By moyer313 in forum Kawasaki Classifieds
    Replies: 2
    Last Post: 04-17-2009, 05:46 AM
  4. 87MM 5 degree nozzle *WTB*
    By BlitzK in forum Yamaha Classifieds
    Replies: 8
    Last Post: 08-07-2008, 06:25 PM
  5. 3 Degree Nozzle Holeshot
    By Gipper in forum Yamaha PWC Performance (2-stroke)
    Replies: 2
    Last Post: 03-21-2007, 07:48 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts