Thread: a little help wit RRFPR
05-30-2008, 04:00 PM #1
a little help wit RRFPR
I have installed the new x/charger, Riva power filter and RRFPR on my friends 05 RXT. Soon to install the 15/22r impeller. The RXT has a stock inercooler.
I have read all the links regarding the RRFPR and the directions where to drill and Tap for the RRFPR. I just want to be sure before I drill a hole into my buddys ski.
can some one post a picture where I should drill? Since the RXT has a stock inercooler I can't drill where the block off would be. Should I remove the intake manafold to drill and tap?
Thanks for your help, we hope to have it out on the water next week and I'll post a report.
05-30-2008, 04:11 PM #2
05-30-2008, 04:16 PM #3
- Join Date
- Jul 2006
- Beaufort, SC
ewwww... 3/32 hole for a rrfpr source....little small. do you have a wideband available?
05-30-2008, 04:24 PM #4
05-30-2008, 04:34 PM #5
05-30-2008, 04:43 PM #6
05-30-2008, 05:05 PM #7
05-30-2008, 06:18 PM #8
Thanks, I thought that was the location. Can't wait to try it.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By lafjax in forum 4-Tec PerformanceReplies: 18Last Post: 09-08-2006, 07:00 PM
By Top banana in forum 4-Tec PerformanceReplies: 11Last Post: 08-07-2006, 03:12 AM
By beachboy66 in forum 4-Tec PerformanceReplies: 2Last Post: 07-20-2006, 07:38 AM
By CRAZEDRXP in forum Sea Doo Open DiscussionReplies: 18Last Post: 06-01-2006, 02:38 PM
By Angelse68cal in forum 4-Tec PerformanceReplies: 6Last Post: 08-04-2005, 07:57 PM