Thread: vts plastic nut
06-02-2008, 08:53 AM #1
- Join Date
- May 2008
vts plastic nut
does anyone know what size the plastic nut is that holds the VTS to the hull? also, what did you guys use to remove it, socket perhaps? i cant find one deep enough. thanks in advance.
06-02-2008, 08:56 AM #2
36MM Bro and u have to remove the inner VTS motor and shaft to get to the nut with a socket! good luck!
06-02-2008, 08:56 AM #3
06-02-2008, 08:58 AM #4
that 20.00 dollar bill looks a lil easier Dave! i just didnt have one! hahahahahaha
06-02-2008, 09:01 AM #5
06-02-2008, 09:04 AM #6
Aye its a life saver! Also helps with removing the fittings off the rideplate before you remove it. So it has 2 uses!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By MadMtnMikey in forum 2-Stroke PerformanceReplies: 4Last Post: 06-19-2013, 12:40 AM
By kwr in forum Yamaha ClassifiedsReplies: 1Last Post: 08-01-2010, 09:57 AM
By ncdoo in forum Yamaha Open DiscussionReplies: 2Last Post: 11-27-2009, 04:09 PM
By lt1transam in forum 2-Stroke PerformanceReplies: 3Last Post: 07-17-2008, 11:02 PM
By 1BAD07RXP in forum 4-Tec PerformanceReplies: 25Last Post: 01-08-2008, 04:08 AM