06-07-2008, 06:00 PM #1
JWilson and Kman's GIO catch can mod
I just completed Mod as described by JWilson and Kman and am eager to try it out.
Given the length of hose I used, I find the original drain hose (the one that went from the bottom of catch can to oil pan) is now touching what I think is the intake manifold (is that was it is called?). You know that thing under the fuel rail. I have attached a picture below (I hope).
Does the intake manifold get hot enough to melt this hose if the hose is touching the manifold?
06-07-2008, 06:09 PM #2
- Join Date
- Jan 2007
I would not worry about it. You should see my getto HD/Lowes catch can. I think you need a catch can and the hose raised to stop most if not all of it.
I am betting on what ES has to offer will be affordable and nice looking.
06-07-2008, 06:19 PM #3
06-07-2008, 08:10 PM #4
06-07-2008, 10:24 PM #5
The release date is Sunday 6.8.08 - tomorrow!!!
06-10-2011, 03:25 PM #6
06-13-2011, 12:25 AM #7
so in the event of a roll over it still can return oil to the sump and not starve the engine,
it collects the condensated fumes, and allows you to external drain with out contaminating the oil in the sump .
Not only does it collect fuel , it also collects water aswell
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Kinchyle in forum Sea Doo Open DiscussionReplies: 37Last Post: 06-07-2015, 11:11 AM
By TXVXrider in forum Yamaha PWC Performance (4-stroke)Replies: 5Last Post: 01-31-2011, 08:43 PM
By toofast in forum Kawasaki PWC Performance (4-stroke)Replies: 0Last Post: 04-27-2010, 08:47 PM
By US PERFORMANCE in forum Kawasaki PWC Performance (4-stroke)Replies: 12Last Post: 07-05-2007, 08:51 AM
By Red Devil in forum 4-Tec PerformanceReplies: 13Last Post: 08-07-2006, 11:38 AM