Thread: degree wheel question
06-08-2008, 08:45 PM #1
degree wheel question
where is the better attachment of the degree wheel? in mag or pto side???? can i also ask how big mm is the thread on the crankshaft so, i could know how big il will put a hole in my degree wheel....??
06-08-2008, 10:19 PM #2
PTO, this way you can perform work at the MAG area and not be bothered with the degree wheel.
If you use a paper degree wheel (attached to cardboard), you can put it over the coupler and then tape it to the coupler.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By toolin in forum 2-Stroke PerformanceReplies: 1Last Post: 09-02-2008, 03:04 PM
By toolin in forum 2-Stroke PerformanceReplies: 0Last Post: 09-02-2008, 11:37 AM
By andy95'slx780 in forum Polaris Open DiscussionReplies: 4Last Post: 07-08-2008, 06:29 AM
By Gappa in forum 2-Stroke PerformanceReplies: 4Last Post: 09-17-2007, 08:26 PM
By Kinchyle in forum 4-Tec PerformanceReplies: 17Last Post: 08-17-2005, 01:01 PM