Thread: riva free flow question
06-13-2008, 08:35 AM #1
riva free flow question
i have installed the entire rpm kit on my 15f except the free flow.
i have a couple of questions....
has anyone noticed higher temps under the seat, hot enough to melt or damage anything, including the rear bucket ?? also, how does your ski perform after hours of riding due to heat soak ? will the powder coat peel quickly ? i was thinking to maybe have the pipe sandblasted and then JET HOT coated inside and out ??
any input is much appeciated
06-17-2008, 10:17 AM #2
I have had the free flow exhaust on my 15f for @ 75 hours, no noticeable heat increase, nothing has melted, and its not peeling, it runs pretty much the same all day long...........
06-17-2008, 04:57 PM #3
no heat difference on mine...you might have missed a water line or your water jacket is not getting water
06-18-2008, 08:55 AM #4
the only reason i ask, is b/c i read somewhere in a thread that someone had melted plastic pieces over by the valve covers where the kn's go.
06-18-2008, 10:22 AM #5
yeah not sure...I have blockoffs so no melting of anything going to happen
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By LT1GMC in forum Yamaha PWC Performance (2-stroke)Replies: 2Last Post: 11-24-2011, 05:03 PM
By jb08rxp-x in forum 4-Tec PerformanceReplies: 10Last Post: 11-14-2008, 12:14 PM
By inchadeboca in forum Kawasaki PWC Performance (4-stroke)Replies: 5Last Post: 06-28-2008, 09:09 PM
By HYNES in forum Kawasaki PWC Performance (4-stroke)Replies: 6Last Post: 03-31-2008, 07:55 PM
By jcorallo in forum Yamaha PWC Performance (2-stroke)Replies: 16Last Post: 08-26-2007, 12:18 AM