Thread: Paging Shibby!
07-03-2006, 12:38 AM #1SeaDoocerGuest
A while back you had a post with a list of everything to do when changing out the wear ring from start to finish...I need to know where I can go to find that. I have someone that needs to know and the info you provided had every nut and bolt listed you would have to take off! Thanks
07-03-2006, 12:44 AM #2
Jarret and Jerry made a nice little formal thread about this in the FAQ maintenance section of the forum...
check out this thead, should be pretty helpful?
-remove steering (10mm), reverse (10mm), and OPAS linkages (13mm)
-remove four 13mm bolts that hold venturi to pump
-remove clamp holding hose from venturi to OPAS water splitter in top of hull
- remove four 17mm nuts holding pump to pump support
and pull her off
07-03-2006, 12:46 AM #3
and dont forget the freezer trick! works like a charm every time on skis with metal pumps... dont leave it in the freezer too long or it will shrink the ring too much and get it stuck on the prop.... 45 minutes usually does it for me and it slides right out.
07-03-2006, 08:43 AM #4SeaDoocerGuest
Yep, and , thanks...I'll pass it on. BTW, did you get your ski back and how's she running?
07-03-2006, 10:08 AM #5
almost together.... probably finish it up 2nite... just have to slap an air intake on there and put in the whole exhaust and it's water-worthy in a rather stock mildly-modded format.
we'll see what happens, i'll keep u posted.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By wavehummer in forum Sea Doo Open DiscussionReplies: 1Last Post: 08-08-2007, 10:00 AM
By Pale Rider in forum Sea Doo Open DiscussionReplies: 19Last Post: 11-26-2006, 12:51 PM
By mxl16 in forum 4-Tec PerformanceReplies: 7Last Post: 06-24-2005, 10:36 AM
By Jrsrxp in forum 4-Tec PerformanceReplies: 0Last Post: 06-01-2005, 07:14 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 6Last Post: 05-25-2005, 08:43 AM